DIY Laundry Basket Dresser

Your laundry room won’t be the same after this. It will be so much better! This dresser/basket combo will help you organize those piles of dirty (or clean) laundry like a pro.

Anna White has a tutorial on how to build this “dresser” and it is absolutely wonderful. Once you have that done, head to the store and buy your baskets! Voila! Laundry Room transformation.

The Laundry Basket Dresser has taken my laundry room from the messiest room in my home to the tidiest. It’s so easy to pull laundry out and put it directly into baskets. I then can take each basket to it’s respective room and fold and put laundry away. For any busy home, these are a must.

 All your laundry baskets could be like drawers in a dresser.

For each of these laundry basket dressers, you will need three of these baskets.

Dimensions

Dimensions:

Dimensions:

Dimensions are shown above.

Materials and Tools

Shopping List:

3/4″ Plywood cut into 15 1/2″ wide x 8 feet long strips (referred to as 1x16s)
1/4″ Plywood for the backs
1 1/2″ x 1 1/2″ metal angle (ask for it at Blue or Orange)
2″ wood screws or 1 1/4″ pocket hole screws
3/4″ wood screws (to screw the metal angle to the insides of the boxes)
1 1/4″ wood screws
wood glue
wood filler
finishing supplies

Tools:

measuring tape

square

pencil

safety glasses

hearing protection

drill

circular saw

sander

level

countersink drill bit

 

Cut List

Cut List:

2 – 1×16 @ 35 1/4″ (Sides)
1 – 1×16 @ 24 1/2″ (Bottom)
1 – 1×16 @ 26″ (Top)
1 – 1/4″ Plywood @ 36″ x 25 3/4″ (Back)
6 – 1 1/2″ x 1 1/2″ Metal Angle 15 1/2″ long (ask hardware store to cut or cut with a hack saw)

Step 1

Build the Box

I used pocket holes, but you can also use 2″ wood screws countersunk and screwed together to build the box.

NOTE: Top Measurement should be 26″

Step 2

Back

Adjust for square then screw the back on with 1 1/4″ screws and glue. I finished mine at this stage by filling all holes with wood filler, all plywood edges, and any imperfections in the plywood. I then sanded with coarse sandpaper because the plywood was builder grade cheapo stuff, the finished with medium sandpaper. Finally, I primed and painted with ooops paint in semigloss from Valspar.

Source